Sticking to an Eave Plate
Install the sheet of vapor/vapour retarder over the eave plate and stick it onto the tie beam using
ORCON F, in order to form seal between the eave plate and the tie beam too.

ORCON F
Joint adhesive for junctions with adjoining building components, e.g. plastered masonry or wood.

Adhesive Tapes
pro clima adhesive tapes for bonding air-proofing membranes have very high tack (initial adhesiveness). The high final adhesion achieved by the bond is reached very quickly. The adhesive tape is made of a non-ageing acrylate which is free of solvents or softeners. This, combined with its high UV and temperature resistance, ensures long-lasting bond.

Laying Parallel to the Sub-Structure
Laying the sheets along the sub-structure, for example along the rafters, has the advantage that the overlap has a firm foundation. It is therefore possible to exert a lot of pressure on the tape. The overlap isn’t subjected to forces by the thermal insulation, allowing an ideal bond to be formed.

Installing at Right Angles to the Sub-Structure
When applying the sheets of retarders at right angles to the sub-structure, for example at right angles to the rafters, make sure that the sheets of INTELLO^® or INTELLO^® PLUS vapour retarder are stretched tight to allow as much pressure is possible to be exerted when applying the tape. Since the insulation is resting on the overlap and may exert a force on it, ensure that you apply the tape centrally. If using blown-in insulation the installation long the sub-structure is recommended. If installing at right angles, affix laths below and parallel to the tape in order to reduce the load exerted on the tape by the insulation. Or apply additional tape at right angles to the overlap every 30 cm.

UNI TAPE
Single-sided adhesive tapes for bonding sheet overlaps.

Sealing of Windows and Purlins with smooth surface
Apply the vapor/vapour retarder into the groove and use TESCON PROFIL to create an uninterrupted airtight seal around window frames or frames of roof windows.
Use pro clima TESCON PROFIL to create an airtight seal around holes.

TESCON PROFIL
Single-sided adhesive tapes for junctions at windows or doors and for corner bonding.

Installation Parallel to the Sub-Structure
Installing the sheets along the sub-structure, for example along the rafters, has the advantage that the overlap has a firm foundation. It is therefore possible to exert a lot of pressure on the tape. The overlap isn’t subjected to forces by the thermal insulation, allowing an ideal bond to be formed.

Installing at Right Angles to the Sub-Structure
When applying the sheets of retarders at right angles to the sub-structure, for example at right angles to the rafters, make sure that the sheets of INTELLO^® or INTELLO^® PLUS vapour retarder are stretched tight to allow as much pressure is possible to be exerted when applying the tape. Since the insulation is resting on the overlap and may exert a force on it, ensure that you apply the tape centrally. If using blown-in insulation the installation long the sub-structure is recommended. If installing at right angles, affix laths below and parallel to the tape in order to reduce the load exerted on the tape by the insulation. Or apply additional tape at right angles to the overlap every 30 cm.

UNI TAPE
Single-sided adhesive tapes for bonding sheet overlaps.