Photo gallery, Installation: 1. Holzrahmenbau

Photo gallery, Installation: 2. Holzrahmenbau

Photo gallery, Installation: 3. Mauerwerks-/Betonbau

Photo gallery, Installation: 4. Mauerwerks-/Betonbau

General conditions

The bonds should not be subjected to tensile strain.
Press firmly to secure the adhesive tapes in place. Ensure that there is sufficient resistance pressure.
Airtight seals can only be achieved if the sealing tape is installed free of folds and breaks.
Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary.
If the airtight connection is created straight after plastering, moisture ingress may occur in the thermal insulation or to problems in the order of construction.

Substrate

Before adhesion is carried out, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air.
Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. Subsurfaces must be sufficiently dry and stable.

Permanent adhesion is achieved on all pro clima interior membranes and on other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium). Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels).
For bonding joints on masonry or concrete or on rough substrates, use ORCON F.

The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.



System warranty

We do not leave you on your own. Read here about how extensive the pro clima system warranty is in the worst-case scenario

more