CONTEGA SL
Installation steps: 1. Timber frame structures
Schematic diagram
If the window is already installed, CONTEGA SL is stuck to the frame.
Schematic diagram
If the window is already installed, CONTEGA SL is stuck to the frame.
1a. Remove the inner release film
Remove one of the release film strips on the membrane side (smooth side).
1a. Remove the inner release film
Remove one of the release film strips on the membrane side (smooth side).
1b. Stick to the frame
Place the full width of the adhesive strip of the tape onto the frame and stick the first reveal side.
1b. Stick to the frame
Place the full width of the adhesive strip of the tape onto the frame and stick the first reveal side.
1c. Preparation of corners
Fold the tape in the corner area. Ensure that there is uninterrupted airtight adhesion at the window. Then continue sticking around the rest of the frame. When finished, cut the tape, allowing approx. 5 cm of an overlap.
1c. Preparation of corners
Fold the tape in the corner area. Ensure that there is uninterrupted airtight adhesion at the window. Then continue sticking around the rest of the frame. When finished, cut the tape, allowing approx. 5 cm of an overlap.
1d. Stick to the reveal
Remove the second strip of release film from the smooth membrane side and stick the tape all around the reveal.
1d. Stick to the reveal
Remove the second strip of release film from the smooth membrane side and stick the tape all around the reveal.
1e. Rub the tape firmly to secure the adhesive bond
Rub the tape firmly onto the reveal and frame. This step can be carried out more efficiently and in a manner that is kinder to your hands by using the pro clima PRESSFIX application tool.
1e. Rub the tape firmly to secure the adhesive bond
Rub the tape firmly onto the reveal and frame. This step can be carried out more efficiently and in a manner that is kinder to your hands by using the pro clima PRESSFIX application tool.
1f. Tape the ends
In the area where the tape ends are to be stuck, remove the release films on the fleece side to approx. 4 cm to the left and right of the joint.
1f. Tape the ends
In the area where the tape ends are to be stuck, remove the release films on the fleece side to approx. 4 cm to the left and right of the joint.
1g. Tape the ends
Stick the overlap joint of CONTEGA SL with a short piece of TESCON VANA all-round adhesive tape. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond. You’re finished!
1g. Tape the ends
Stick the overlap joint of CONTEGA SL with a short piece of TESCON VANA all-round adhesive tape. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond. You’re finished!