Photo gallery, Installation: Situation 1

Photo gallery, Installation: Situation 2

Photo gallery, Installation: weitere Situationen

General conditions

The bonds should not be subjected to tensile strain.
Press the adhesive tapes firmly to secure them, taking care to ensure that there is sufficient resistance pressure behind them.
Airtight seals can only be achieved if the sealing tape is installed free of folds and breaks. Ventilate regularly and systematically to prevent build-up of excessive humidity. Use a dryer if necessary.

Substrate

Before adhesion is carried out, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air.
Uneven mineral subsurfaces may need to be levelled with a smooth finish.
Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. Subsurfaces must be sufficiently dry and stable.

Permanent adhesion is achieved on all pro clima interior membranes and on other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium). Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels) and on mineral subsurfaces such as concrete and masonry.

The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.



System warranty

We do not leave you on your own. Read here about how extensive the pro clima system warranty is in the worst-case scenario

more