Photo gallery, Installation

General conditions

The bonds must not be subjected to tensile forces. It may be advisable to use mechanical reinforcements.
Rub the bond firmly into place (e.g. using the pro clima PRESSFIX application tool).
The product achieves its final level of strength after approx. 24 h.

Substrate

Before adhesion is carried out, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air. Mineral surfaces (plaster or concrete) may be slightly moist.
Adhesion to frozen surfaces is not possible. The substrate material must be free of water-repellent substances (e.g. grease or silicone). Subsurfaces must be stable - if necessary, a mechanical support (pressure lath) must be used (e.g. on crumbling subsurfaces).

Permanent adhesion is achieved on all pro clima interior and exterior membranes, other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium) as well as other underlay/sarking and wall lining membranes (e.g. those made of PP and PET).
Bonds can be created on mineral subsurfaces (e.g. plaster or concrete), roughly sawn, planed and painted wood, hard plastics and rustproof metal (e.g. pipes, windows etc.) and hard wood-based panels (chipboard, OSB, plywood, MDF panels).

The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.



System warranty

We do not leave you on your own. Read here about how extensive the pro clima system warranty is in the worst-case scenario

more