AEROSANA VISCONN white
General installation steps
1. Prepare the subsurface; stir the product
Subsurfaces should be cleaned. An even subsurface is a prerequisite for the use of AEROSANA VISCONN white spray film. Fill any breakages, joints or holes before applying it.
General installation steps
1. Prepare the subsurface; stir the product
Subsurfaces should be cleaned. An even subsurface is a prerequisite for the use of AEROSANA VISCONN white spray film. Fill any breakages, joints or holes before applying it.
General installation steps
2a. Cover over defects
Breakages, joints and holes can be covered over with a suitable filler or with CONTEGA SOLIDO SL before AEROSANA VISCONN white is sprayed on.
If defects are detected during spraying, these can be covered over with pro clima AEROSANA FLEECE.
2a. Cover over defects
Breakages, joints and holes can be covered over with a suitable filler or with CONTEGA SOLIDO SL before AEROSANA VISCONN white is sprayed on.
If defects are detected during spraying, these can be covered over with pro clima AEROSANA FLEECE.
2b. Cover over defects
To do this, paint AEROSANA VISCONN white onto a piece of fleece, apply the fleece to the defect and spray over it.
2b. Cover over defects
To do this, paint AEROSANA VISCONN white onto a piece of fleece, apply the fleece to the defect and spray over it.
3. Apply a spray film (airless spray process)
Apply AEROSANA VISCONN white in at least two layers.
Apply the spray film in an even and overlapping manner.
Additional layers may be necessary, depending on the condition of the subsurface.
In the case of a layer thickness of greater than 1 mm, first allow AEROSANA VISCONN white to become touch dry and then proceed to add further layers.
Layers of liquid film that are too thick can run off.
Setting of airless sprayer
Pressure: Approx. 150 - 200 bar
Nozzles: 210, 317, 519
3. Apply a spray film (airless spray process)
Apply AEROSANA VISCONN white in at least two layers.
Apply the spray film in an even and overlapping manner.
Additional layers may be necessary, depending on the condition of the subsurface.
In the case of a layer thickness of greater than 1 mm, first allow AEROSANA VISCONN white to become touch dry and then proceed to add further layers.
Layers of liquid film that are too thick can run off.
Setting of airless sprayer
Pressure: Approx. 150 - 200 bar
Nozzles: 210, 317, 519
4. Use as a primer
Rough or dusty subsurfaces can be prepared for sticking pro clima adhesive tapes to them by using AEROSANA VISCONN white.
To do this, apply a seamless layer of spray film.
4. Use as a primer
Rough or dusty subsurfaces can be prepared for sticking pro clima adhesive tapes to them by using AEROSANA VISCONN white.
To do this, apply a seamless layer of spray film.
5. Stick joints
Once the spray has dried, apply the adhesive tape and gradually stick it in place.
When plastering, please observe the recommendations of the plaster manufacturer for non-absorbent subsurfaces.
A bonding course may be necessary.
5. Stick joints
Once the spray has dried, apply the adhesive tape and gradually stick it in place.
When plastering, please observe the recommendations of the plaster manufacturer for non-absorbent subsurfaces.
A bonding course may be necessary.