CONTEGA EXO
Installation steps: 1. Timber frame structures
Schematic diagram
If the window is already installed, CONTEGA EXO is stuck to the frame.
Schematic diagram
If the window is already installed, CONTEGA EXO is stuck to the frame.
1. Remove the inner release film
Remove one of the release film strips on the membrane side (smooth side).
1. Remove the inner release film
Remove one of the release film strips on the membrane side (smooth side).
2. Stick to the frame
Place the full width of the adhesive strip of the tape onto the frame and stick the first reveal side.
2. Stick to the frame
Place the full width of the adhesive strip of the tape onto the frame and stick the first reveal side.
3. Preparation of corners
Fold the tape in the corner area. Ensure that there is uninterrupted windtight adhesion to the window. Then continue sticking around the rest of the frame. When finished, cut the tape, allowing approx. 5 cm (2") of an overlap.
3. Preparation of corners
Fold the tape in the corner area. Ensure that there is uninterrupted windtight adhesion to the window. Then continue sticking around the rest of the frame. When finished, cut the tape, allowing approx. 5 cm (2") of an overlap.
4. Stick to the reveal
Remove the second strip of release film from the smooth membrane side and stick the tape all around the reveal.
4. Stick to the reveal
Remove the second strip of release film from the smooth membrane side and stick the tape all around the reveal.
5. Rub the tape firmly to secure the adhesive bond
Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.
5. Rub the tape firmly to secure the adhesive bond
Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.
6. Stick the ends
Remove the outer strip of release film from the smooth membrane side along a short length. Note: ORCON F will not stick to the release film. Apply an approx. 5 mm (3/16") thick line of ORCON F joint adhesive between the overlapping ends of the tape.
6. Stick the ends
Remove the outer strip of release film from the smooth membrane side along a short length. Note: ORCON F will not stick to the release film. Apply an approx. 5 mm (3/16") thick line of ORCON F joint adhesive between the overlapping ends of the tape.
7. Stick the ends
Place the tape onto the adhesive. You’re finished!
7. Stick the ends
Place the tape onto the adhesive. You’re finished!