CONTEGA EXO
Installation steps: 3. Masonry/concrete structures
Schematic diagram
If the window is already installed, CONTEGA EXO is stuck to the frame.
Schematic diagram
If the window is already installed, CONTEGA EXO is stuck to the frame.
1. Stick to the frame
Remove one of the release film strips on the smooth membrane side. Place the full width of the adhesive strip of the tape onto the frame and stick the first reveal side. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.
1. Stick to the frame
Remove one of the release film strips on the smooth membrane side. Place the full width of the adhesive strip of the tape onto the frame and stick the first reveal side. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.
2. Remove the inner release film
Remove the inner strip of release film on the first reveal side as far as the first corner.
2. Remove the inner release film
Remove the inner strip of release film on the first reveal side as far as the first corner.
3. Preparation of corners
Fold the tape in the corner area. Ensure that there is uninterrupted windtight adhesion to the window. Then continue sticking around the rest of the frame. When finished, cut the tape, allowing approx. 5 cm (2") of an overlap.
3. Preparation of corners
Fold the tape in the corner area. Ensure that there is uninterrupted windtight adhesion to the window. Then continue sticking around the rest of the frame. When finished, cut the tape, allowing approx. 5 cm (2") of an overlap.
4. Apply adhesive to surface
Apply a line of ORCON F joint adhesive to the reveal in a compact zig-zag pattern.
4. Apply adhesive to surface
Apply a line of ORCON F joint adhesive to the reveal in a compact zig-zag pattern.
5. Place the tape onto the adhesive
Remove the inner release film all the way around. Note: ORCON F will not stick to the release film. Place the tape onto the adhesive. Do not press the adhesive completely flat so as to allow for relative motion between components.
5. Place the tape onto the adhesive
Remove the inner release film all the way around. Note: ORCON F will not stick to the release film. Place the tape onto the adhesive. Do not press the adhesive completely flat so as to allow for relative motion between components.
6. Stick the ends
Apply an approx. 5 mm (3/16") thick line of ORCON F joint adhesive between the overlapping ends of the tape. Place the tape onto the adhesive. Do not press the adhesive completely flat so as to allow for relative motion between components.
6. Stick the ends
Apply an approx. 5 mm (3/16") thick line of ORCON F joint adhesive between the overlapping ends of the tape. Place the tape onto the adhesive. Do not press the adhesive completely flat so as to allow for relative motion between components.
7. Remove the outer release film
Remove the outer strip of release film (on the fleece side) all the way around. Note: plaster will not adhere to the release film. CONTEGA EXO can be plastered over.
7. Remove the outer release film
Remove the outer strip of release film (on the fleece side) all the way around. Note: plaster will not adhere to the release film. CONTEGA EXO can be plastered over.