Full-surface adhesive plaster and window sealing tape for exterior use with an additional adhesive zone

 

Advantages

  • Saves time: the joint is immediately resistant to driving rain and can be subjected to loading
  • Easy to work with thanks to the additional adhesive zone on the fleece side
  • Can be plastered over directly: defined transition between window and/or wind sealing and plaster
  • Reliable joints: waterproof SOLID adhesive has extremely strong adhesion on mineral subsurfaces too
  • Independently confirmed suitability: tests in accordance with MO-01/1 passed at IFT in Rosenheim (DE)
 

Application

For exterior windtight joints that are resistant to driving rain between windows or doors and adjacent building components made of wood or mineral subsurfaces such as concrete and masonry, full-surface adhesion.
The adhesive zone on the fleece side allows for easier adhesion to windows and doors if applied before they are installed.
The stuck joint is immediately windproof and can be subjected to loading. The fleece can simply be plastered over in accordance with the application guide.

Photo gallery, Installation 1. before the window is installed

Photo gallery, Installation 2. window already installed

General conditions

The bonds should not be subjected to tensile strain.
Press firmly to secure the adhesive tapes in place. Ensure that there is sufficient resistance pressure.
Seals that are windproof and resistant to driving rain can only be achieved if the sealing tape is installed free of folds and breaks.

Substrate

Clean subsurfaces before sticking.
Uneven mineral subsurfaces may need to be levelled with a smooth finish.
Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded.
The width of the adhesive tape that is to be plastered over should generally not exceed 60 mm (2 3/8") or 50 % of the soffit area. Detailed recommendations can be obtained from the relevant plaster producer.
Subsurfaces must be sufficiently dry and stable.

Permanent adhesion is achieved on all pro clima exterior membranes and on other underlay/sarking and wall lining membranes (e.g. those made of PP and PET).
Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels) and on mineral subsurfaces such as concrete and masonry.

The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.



System warranty

We do not leave you on your own. Read here about how extensive the pro clima system warranty is in the worst-case scenario

more